#2249. Pku3896 Multiprocessor Scheduling

内存限制:128 MiB 时间限制:10 Sec

题目描述

There are two applications running on a multiprocessor machine. Each application i (i=1,2) consists of N procedures which are numbered from 1 to N and must be executed sequentially (in the order 1,...,N). A procedure will be identified by a pair (i,j), where i=1,2 identifies the application and 1≤j≤N represents the index of the procedure in the sequence of procedures of the application i. A procedure (i,j) can only be executed on the processor P(i,j) of the machine and its execution lasts for D(i,j) seconds. We want to schedule the execution of the procedures of the two applications over the processors of the machine in such a way that the time moment when the last procedure finishes its execution (from any of the two applications) is minimum; this time moment is called makespan. We consider that the two applications are available for scheduling starting from the time moment 0. The schedule needs to obey the following rules:


once the execution of a procedure (i,j) starts on the processor P(i,j), we cannot interrupt it until the execution of the procedure ends
we cannot execute multiple procedures on the same processor at the same time, but we can execute multiple procedures in parallel on different processors
the execution of the procedure (i,j) (2≤j≤N) starts either at the exact time moment tm when the procedure (i,j-1) finishes its execution or at any time moment after tm
if a procedure begins its execution at time moment tm, then it will finish its execution at the time moment tm+D(i,j)


有两组任务,每组都有N个任务,现在将这些任务放到一些处理器中处理,条件如下: 
1.任意一组任务必须按顺序完成,也就是必须先做完前i-1个才能做第i个。 
2.某个任务只能在指定的处理器(编号不超过10)上做。 
3.一个处理器同一时间只能处理一个任务,并且不允许中断。 
求完成两组任务的最短时间。

输入格式

Write a program that, given the information regarding the procedures of the two applications, computes the minimum makespan.

The first line of the input file contains the number T of test cases which are described next. The first line of a test case contains the number N (1≤N≤300) of procedures composing each of the two applications. Then, N lines follow, describing the first application. The jth of these N lines contains two integers, separated by a blank: P(1,j) and D(1,j). After this, other N lines follow, describing the second application. The jth of these N lines contains two integers, separated by a blank: P(2,j) and D(2,j). We have 1≤P(i,j)≤10 and 1≤D(i,j)≤15000 (i=1,2; 1≤j≤N). Notice that we may have P(i,j)=P(k,l) – this implies that the procedures (i,j) and (k,l) cannot be executed during overlapping time intervals (notice also that if i=k this would not matter, as the procedures of the same application must be executed sequentially).

输出格式

The output file must contain exactly T lines with a single number each – the minimum makespan for the corresponding test from the input file. These answers must be printed in the order in which the test cases are given in the input file (i.e. the ith line of the output file contains the answer to the ith test case from the input file).

样例

样例输入


			
2
1
2 6
1 10
3
2 31
2 18
4 15
2 26
3 40
5 16

样例输出


			
10
90

数据范围与提示